Wolf Garten Robo Scooter 500, Оригинальная инструкция по эксплуатации

Страница: 54 / 138

54
en
Chapter 8 - Fault Problems
Problem Encountered Probable Cause/Event Corrective/User Action
Robo Scooter 500 ope-
rates at the wrong times
• Confirm that the time in the mower is set correctly
(hour and date)
• Set the time
• The ‘GO’ button was pressed with no meaning, by so-
meone or by a pet (‘Last stop cause’ under the ‘Infor-
mation’ menu should be 805).
• To prevent unintended operation you can activate the
‘Child guard’ option, which requires pressing of few
buttons in order to start the operation.
Robo Scooter 500 has
skipped the scheduled
operation
• Low battery voltage
• Rain detected at the scheduled time
• Some obstacle is stuck or wrapped around the blade
prevent it rotating.
• Signal problem
• In general, whenever Robo Scooter 500 does not start
the operation at the scheduled time, the cause is re-
corded under ‘Program Display’.
• The program was set to ‘off’ – the main display shows
‘Mow Zone: Base’ and not the time and the next start
details. • Change the setting of the ‘Program’ to ‘on’
'Cut wire’ indicator flas-
hing on Perimeter Switch
or the Base Station
beeps continuously for
'Cut wire’
• Wire disconnected from perimeter switch or from the
Base Station.
• Confirm wire is plugged in and wire leads are firmly at-
tached.
• Perimeter wire cut
• Walk along perimeter, including islands and look for
obvious cuts or breaks in the wire. Repair with Robo-
mow wire splice connectors.
1. Strip 1cm (0.5 inch) of each wire ends together and
twist the stripped ends together using pliers
2. Insert the twisted wires into the splicing connector.
3. Screw the wire connector on the twisted wires; make
sure is tight.
1
Attention!
Twisted cables, or a screw terminal, insulated with
insulation tape is not a satisfactory splice. Soil
moisture will cause the conductors to oxidize and
after a while result in broken circuit.
• Poor connections
• Check and repair all loose/poor or corroded connec-
tions.
‘Poor connection’ indica-
tor flashing on Perimeter
Switch or the Base Stati-
on beeps intermittently
for poor wire splicing or
too long wire
• Twisted cables, or a screw terminal, insulated with in-
sulation tape is not a satisfactory splice. Soil moisture
causes the conductors to oxidize and after a while re-
sult in broken circuit. • Use the connectors supplied in the box. It is water-
proof and gives a reliable electrical connection.
• Perimeter wire too long for one zone
• A maximum perimeter wire length of 500 m is recom-
mended. Areas requiring longer lengths should be
broken into separate zones.
Robomow will not opera-
te and nothing will dis-
play on the LCD screen.
• Mower is in deep sleep.
• If not connected to the Base Station/charger at all
times when not in use, the Robomow will conserve po-
wer by entering into a deep sleep mode. Press the
main switch button (on/off) 3 seconds continuously to
wake Robomow or remove the fuse for 3 seconds.
• Batteries have been discharged from lack of charge
maintenance.
• It is required for the charger to remain connected to
Robomow when not in use. Failure to do so can cause
permanent damage to the batteries. Contact your ser-
vice provider.