Wolf Garten Robo Scooter 500, Оригинальная инструкция по эксплуатации

Страница: 48 / 138

48
en
Chapter 6 - Maintenance and Storage
1
Warning!
Blade is very sharp and can cause severe cuts or lacerations.
z
Always remove batteries fuse before any maintenance or
cleaning is done or before lifting Robo Scooter 500.
z
Always wear heavy work gloves when working with and
around the blade.
Recommended Maintenance Schedule
Cleaning
1
Attention!
Never use harsh or abrasive cleaning solutions. Never spray
with a garden hose or other type of liquid spray hose.
z
Use only a damp cloth and a dry brush to clean the outer
surfaces.
z
A light detergent can be used in a water solution, and then
soaking and wringing dry the cloth for cleaning.
Robo Scooter 500
z
The underside of the mowing deck needs to be inspected, and
cleaned if necessary, between operations. The Robomow is a
dedicated mulching mower and may accumulate clippings under
the mowing deck, particularly when mowing wet and damp grass.
z
Most grass accumulation can be removed using a small wooden
stick or similar object. Carefully scrape the collected grass debris
from under the mowing deck. If necessary, remove the blade to
gain better access to the mowing chamber in order to clean it. Do
not place the mower upside down, damage to the bumper can oc-
cur. Instead, lean it against another surface to gain access to the
mowing deck area.
Base Station
z
Keep the Base Station entrance and area clean from leaves,
sticks and twigs and any other debris that may tend to collect in
these areas. Do not spray a water hose directly onto or into the
Base Station. Use a damp rag and brush to clean the outer sur-
face.
Replacing the Blade
1
Warning!
Blade is very sharp and can cause severe cuts or lacerations.
z
Always remove batteries fuse before any maintenance or
cleaning is done or before lifting Robo Scooter 500.
z
Always wear heavy work gloves when working with and
around the blade.
1
Warning!
Machine sharpening is not recommended, as a good balance
cannot be achieved after machine sharpening.
Maintenance Service
Interval
Maintenance Procedure
Regularly
• Remove the batteries fuse and check
any damage on the blade.
• Check and remove grass clippings
and dirt from the mowing deck if ne-
cessary, particularly when mowing
wet and damp grass.
• Charge the Robo Scooter 500 batte-
ries after every use.
150 – 200 Hours
• Replace the blade; replace it more fre-
quently if the edges dull in rough or
sandy conditions.
1. Place Robo Scooter 500 on its rear side vertically, lay against a
wall or turn it upside down on a soft surface;
2. To remove blade, using both
hands, squeeze the plastic
lock tabs at the base of the bla-
de.
3. Squeeze the plastic locks tabs
in the arrow direction.
4. Then pull blade assembly off,
away from mower.
5. Holding the replacement blade by its base, push until it is locked
into place. You will hear a click when it locks. If you do not hear
a click, remove blade, and repeat the procedure.