Wolf Garten Robo Scooter 500, Оригинальная инструкция по эксплуатации

Страница: 45 / 138

45 en
Language
Allows the user the option of viewing the LCD text in several different
language versions.
ECO-Mode
The ECO (Economic) mode feature enables operating Robo Scooter
500 using minimum energy required to cut the grass and maintain the
lawn.
3
Note
The ECO mode default is set to 'on'. Operation in ECO mode
reduces Robo Scooter 500 noise level during operation and al-
lows longer operation time. It is recommended to use the ECO
mode only in zones with Base Station, where mowing is more
frequent and a shorter part of the grass is cut.
Signal type
In some circumstances there may be interference to the wire signal
caused by other wire signal activated in adjacent lawn (neighbor that
use robotic lawnmower) or by any other appliance using similar fre-
quency. In case of signal interference, you may see one of the fol-
lowing symptoms (usually close to the neighbor lawn):
z
Robo Scooter 500 is widely swinging when driving along the wire;
z
Robo Scooter 500 changes direction without reaching the wire;
z
Robo Scooter 500 crosses the wire outside the designated area;
z
'Start inside' message is displayed although Robo Scooter 500 is
inside the designated area and the perimeter wire is connected in
the right polarity
3
Note
If your mower faced one of the above symptoms, to change the
signal type call to service.
Wire Position
Allows user to test the wire position in ‘Edge’ mode while the mowing
motors are switched off to prevent any damage to the perimeter wire
after the initial setup of the wire is completed.
Delay operation
This option allows the user to press GO but delay the operation star-
ting time.
To use this option, follow the steps below:
1. Set the ‘Delay operation’ to X hours (choose between 1,2,3…or
up to 8 hours);
2. Switch on the Perimeter Switch (It is operated for 12 hours) and
place the mower inside the lawn towards the perimeter wire;
3. Pressing ‘STOP’ then ‘GO’ (while holding the ‘STOP’ button) will
change the display to ‘Press GO again to skip edge’ and at the
end of the warming up process, the mower will stay in place with
a message ‘Operation delayed – wait…’
4. The mower will start the operation after X hours (as set in the ‘De-
lay operation’ menu) from the ‘GO’ pressing.
Information
The ‘Information’ display is used for information only, it allows the op-
tion to scroll between the following menus:
Operation
Battery
Temperatures
Configuration
Last stop causes
„Total time“: Indicates the total number of
hours the mower has been in operation
„First operation“: Indicates the date, in
which the mower was first operated.
„Battery voltage“ – Displays the current
voltage of the batteries.
„Last run times“ – Indicates the last battery
run time in the last 10 operations, the vol-
tage at the beginning of the operation and
the operation date.
Displays the temperatures on the drive
motors, mowing motor and on the Main
Board.
Displays the configuration of the Robo-
mow: Main Board part number, software
version and Base Station Board part num-
ber.
Displays the last ten stop causes number
and the date of the stop.
Total time
253h47m
First operation
Date: 13/03/08
Battery voltage
12.8 25.5 12.7
1) 2h34m 25.8V
25/05/08
Last run times
Press GO
Mow temp.
+24 C +75 F
Software
5.4v 21/10/07
1) 11 [ 3]
10:35 25/05/08