12
G
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z
Pull out the power plug.
z
Do not touch running blades.
z
Never spray down the lawnmower using water, especially not
at high pressure.
z
Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
z
Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as speci-
fied in the safety regulations following any removal of parts.
z
Only use original WOLF spare parts. Otherwise we can’t gua-
rantee that your mower conforms to the safety regulations.
z
Never park your lawnmower in damp rooms.
z
For safety reasons, replace worn or damaged parts.
Disposal
Assembly
Fasten
handle
bars
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
z
Inlay the cable in the bend protection
.
z
When adjusting the handle height take care that the ca-
ble is not crimped
1. Fold the bottom part of the handle up and screw it tight with
the two hand wheels
.
2. Set the handle to the desired height
.
3. Fold the upper part of the handle out and screw it tight with the
wing nuts
.
Mount the collecting bag
1. Place the chute (1) on the collecting bag flap (2)
.
2. Press the chute from behind onto the collecting bag flap. The
chute is ready for use as soon as it locks into place
.
Operation
Operating times
z
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
z
Please feed cable through the strain relief
.
3
Note: WOLF Flick-Flack®
WOLF Flick-Flack® keeps the cable away from the cutting
unit .
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z
Do not attach the collection bag until your feet are at a
safe distance from the cutting tool.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
Set cut height
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
z
Switch off motor and pull out power plug.
1. Pull the lever out
.
2. Set the desired cutting height
.
3. Press the lever back in
.
Selection of Cutting height
z
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
z
We recommend an average cutting height of 40 mm.
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
A
B
C
D
A
C
B
C
D
E
F
G
E
F
G
H
H
J
K
L
M
N
