Page 42
Figure 4–1: Host IP Settings
Close the control panel and reboot the host computer after making an IP address
change to be sure the change takes effect.
Either reconnect to the installed network
or continue with this direct connection to access the iAM-VIDEO Web GUI
.
Network Connection
When connected to a network, the iAM-VIDEO address will need to be changed to
another address in order to be compatible with the address assignments for that
particular network. Immediately after the host setup is complete, change the iAM-
VIDEO’s address. Make the corresponding address, mask and gateway changes in
the iAM-VIDEO
Network Setup
page. Refer to the
Network Setup
section of this
chapter and Figure 4-11.
Otherwise set the iAM-VIDEO to DHCP address mode by checking the box for ‘Use
DHCP?’ in Network Setup and have your IT administrator assign rights and settings
for operation on the network. Allow enough time for your network’s DHCP server to
recognize a new network device and assign an address after booting.