WITTUR sematic SDS Rel. 3, Инструкция по эксплуатации

Страница: 37 / 45

37
www
.wittur
.com
© WI
TTUR • All rights r
eser
ved
PM.2.004921.EN - 808-001-000 SDS
©
rel 3 · Edition 22 July 2020
Drive - Instruction Manual
The following options are viewed on the display:
− PARAMETERS
− OPENING PARAMETERS
− CLOSING PARAMETERS
− REVERSING SYSTEM
− CHANGE PASSWORD
− RESERVED AREA
• Using keys
ã
and
ä
run through the menu.
• Using the “OK” key, confirm the option
Using keys
ã
and
ä
run through the menu and choose the required option
• Using the “OK” key, confirm the option
• The following options are available:
− “BACK”: press key F1 to restore the MAIN MENU
− “MENU”: press key F3 to restore the MAIN MENU
The following diagram shows the correspondance between speed profiles and available parameters:
01 - Low start speed C1 - Low start speed
02 - Accelleration start C2 - Accelleration start
03 - Accelleration C3 - Accelleration
04 - High speed C4 - High speed
05 - Offset deceleration C5 - Offset deceleration
06 - Deceleration C6 - Deceleration
07 - Low speed C7 - Low speed
8.6.1 Option “Parameters”
The following options are viewed on the display:
•
MLC PARAMETERS
•
INPUTS PARAMETERS
•
OUTPUTS PARAMETERS
•
CLOSED PARKING MODE
•
RESET CURRENT
•
CL REST CURRENT
•
REVERS SYSTEM SPACE
•
SERIAL BUS SETTINGS
•
SMOOTH REOPENING
•
MAX POWER OP
•
SOFT DEGRADATION OP
•
PARK OP NO TORQUE
•
PARK CL LOW TORQUE THRESHOLD
•
PARK CL LOW TORQUE DELAY
For each of the above listed parameter the parameter name is displayed at the top, the current value is displayed at the bottom with the
relevant unit measure; the up/down arrow keys allow changing the current value.
•
The following options are available:
−
“BACK”: press key F1 to restore the MAIN MENU
−
F2 KEY: to open and close the door, to test the modified profile
−
“DRAW”: press key F3 to update the speed profile drawing