Änderungen vorbehalten!
Subject to change without notice!
Blatt/
sheet
PM.7.002883.EN.9
Datum/
date
23.01.2013
Stand/
version
23.01.2013
Geprüft/
approved
WAT/MZE
Overspeed governor EOS
Operating instructions
Before starting installation work:
Only properly trained personnel may carry
out work or have access to the installation
site.
-
attach safety devices to guard (platform or har-
nesses) to prevent it from falling
-
cover any floor openings
-
Secure installation tools or objects against acci-
dental falling
-
lift shaft openings should be cordoned off and
suitable warning signs should be erected when
working in shaft openings
-
work involving electrical equipment should only
be carried out by an electrical engineer or qual-
ified personnel.
1.4
Preparation
Before starting to work it is in your own interest to
ascertain the constructural and spatial conditions
and to check where (workshop or on site) and when
installation operations can or must be carried out. It
is recommended therefore to take into account all
the given circumstances, to plan the various opera-
tional sequences in advance, rather than carrying
them out prematurely and in an unconsidered man-
ner.
On receipt of the delivery, the goods or components
should be checked for correctness and completeness
with the order sheet.
Following should be checked:
-
that factory and order number do correspond
-
that the details on the name plate does corre-
spond to those on the order
1.5
Advice when working on
safety components
Overspeed governors are classified as safety compo-
nents. It is most important to comply with the stan-
dards and guidelines described in this section as
well as those given in the rest of this operating
manual.
These instructions and especially the section
of safety precautions, should be read and
fully understood before working with the
component.
Safety devices require special attention. It is com-
pulsory that they function perfectly to ensure dan-
ger free installation operation.
Operation of safety devices installed ex-works must
be tested immediately.
If it is necessary to disassemble a safety device dur-
ing servicing or repair, it must be reassembled
immediately after this work has been finished.
