Use
17.10.2019
53 / 96
Mandatory
Follow the obligations set out below:
Only perform the water test once the "Leak Finder"program has been
executed and the watch can be submerged in water without any risk!
Perform the test in the water immediately after the "Leak Finder"
program has ended!
The watch can only be safely immersed in water for as long as there is
positive pressure in the housing.
Witschi Electronic AG accepts no liability for watches that are
penetrated by water.
If the display is red, remove the watch from the water!
The positive pressure in the watch is too low and water can penetrate.
ü
The watch has been pressurised.
a) Fill a transparent container with water.
Tip
Use distilled water to avoid limescale deposits on the
watch.
b) Place the watch in the container.
c) Observe the formation of bubbles to locate the leak.
Info
If the leak is very small, the formation of bubbles takes a
few minutes.
ð
The time shown in blue is the time available to locate the leak
without the risk of water penetrating the watch.
