Wintriss SmartPAC2, Руководство пользователя

Страница: 358 / 383

SmartPAC 2 User Manual 1126700
Reporting Downtime and Scrap to LETS G-23
Adjusting the Good Parts Counter
The Run mode Counters screen enables you to increase the Good Parts count to adjust for
count inaccuracies, such as when good parts may be produced but not counted in Setup mode
or during Fault conditions. The count can be increased by up to 1,000 parts at a time.
The Counters screen in Program mode allows you to increase Good Parts by larger amounts
(see Adjusting the Good Parts Counter in Program Mode, next page). This capability is
useful if new firmware is installed in the middle of a job, causing the Good Parts counter to
reset to zero.
Adjusting the Good Parts Counter in Run Mode
To increase the Good Parts count in Run mode, do the following:
1.
Select the GOOD PARTS COUNT field on the Counters screen.
2.
When the Good Parts Entry window (like the window shown in Figure G-14) displays,
key in the number of good parts you want to add (1,000 parts maximum), and press
ENTER. A Confirmation window like the one shown in Figure G-18 displays.
3.
Press the Up (

) cursor key to confirm that you want to change the Good Parts counter
value. You are returned to the Counters screen with your adjustment reflected in the
GOOD PARTS COUNT field
.
You can only increase the value maintained by the Good Parts counter. You cannot decrease the
Good Parts counter except by entering scrap values.
You cannot adjust the Good Parts counter if the CHG GOOD PRTS CNT item on the Security
Access Menu has been set to “NO CHANGES ALLOWED.”
Figure G-18. Good Parts Counter Adjustment Confirmation Window
If you attempt to enter a value greater than 1,000 or one that reduces (rather than increases) the
Good Parts count, an error message will display briefly.
NOTICE
NOTICE
NOTICE