7. Operation
50
WIKA Operating Instructions High Pressure Controller, Model CPC8000-H
GB
1
4
2
3
5
9
9
3
.0
0
/0
6
/2
0
1
7
/GB
IEEE-488 Address
The [IEEE-488 Address] button within the Setup [
] / [Remote] tab provides a place for the operator
to set the IEEE-488 Address. When the [IEEE-488 Address] button is pressed the side bar displays
the numeric key pad where an address from 1 to 31 can be entered.
Figure 7-40 IEEE-488 Address
Ethernet Settings
In the Ethernet section of the Setup [
] / [Remote] tab there are buttons that correspond to Ethernet
parameters. When the button is pressed the numeric key pad or a choice selector will be presented on
the sidebar and an appropriate number or selection can be entered for the respective parameter.
These parameters should be set up to match your host computer.
Figure 7-41 Ethernet Settings
Serial Settings
The “Serial” section in the Setup [
] / [Remote] tab can be viewed by selecting the page down
button [
] on the first page of the [Remote] tab. The Serial setup page has buttons that correspond
to serial communication parameters. When a parameter button is pressed a choice selector will be
presented on the sidebar and an appropriate selection can be entered for the respective parameter.
These parameters should be set up to match your host computer.
Figure 7-42 Serial Settings
