R
20
Stopping the WhisperGen
Manual Stopping
The default setting of the
Heat Manage
option is
OFF
. Unless it is turned
ON
, the WhisperGen
automatically stops once the battery bank is fully charged - you do not need to manually stop the
unit.
Should you wish to manually stop the WhisperGen refer to the following:
1. Hold down
STOP
on the control on the control panel until a beep is heard. The
STOPPING
indicator will light up and “Running down” will be displayed on the control panel. As an anti-
tamper feature, short presses of the
STOP
key are ignored.
In the stopping mode, as indicated by a lit
STOPPING
indicator, the WhisperGen goes through a
shutdown sequence lasting two to five minutes during which the engine is cooled down.
When the WhisperGen has fully stopped, the
STANDBY
indicator lights up and the control panel
displays “WhisperGen”. The WhisperGen must be in the standby mode before it can be started
again.
If a remote switch has been installed to control the WhisperGen, you can also stop the
WhisperGen with the remote switch, refer to section entitled Remote Controlling for more details.
If you stop the WhisperGen manually or from a remote switch when it is auto-charging the battery
bank, the WhisperGen will immediately start again if the battery bank charge level is still below
the set level. To prevent the WhisperGen from restarting, turn the
Auto-charge
option
OFF
, refer
to section entitled Managing the Battery Bank - Auto charging.
R
FAULT
AUTOCHARGE
EXT CONTROL
HEAT MANAGE
STOPPING
RUNNING
STARTING
STANDBY
STOP
START
WTL0006
Running down
