Whirlpool Cabrio WTW6200S, Руководство пользователя

Страница: 78 / 84

6-14
8. Select POWER • wash cycle NORMAL •
START.
9. Verify that the tub fills to the top of the
impeller plate (impeller models), or to a
level above the agitator vanes (agitator
models), but much lower than the SU-
PER Load Size water level.
If the water level does not fill to this lev-
el, replace the machine/motor control
assembly. See Accessing & Removing
the Electronic Assemblies.
TEST #7 Drain/Recirculation
Perform the following checks if washer fails to
drain or recirculate.
1. See Activation of Manual Diagnostic Test
Mode, and perform the Manual: Pumps
test.
2. Remove the console to access the ma-
chine/motor control assembly. See Ac-
cessing & Removing the Electronic As-
semblies.
3. Visually check that the P4 connector is
inserted all the way into the machine/mo-
tor control.
If visual check passes, go to step 4.
If visual check fails, reconnect P4 and
repeat step 1.
4. Remove connector P4 from the machine/
motor control and check resistance val-
ues of pump motor windings. Resistance
values should match those shown in wir-
ing diagram, page 7-1.
If resistance values are good, go to
step 7.
If winding measurements are much
higher (tens of ohms to infinity) than
shown in wiring diagram, a problem
exists in the motor winding or in the
connection between the machine/motor
control and the motor. Go to step 5.
5. Tilt machine forward to access the bot-
tom of the machine and the pumps. See
Figure 1, page 6-13.
•
•
•
•
•
6. Check the resistance at the pump motor.
Remove the connector at the motor and
take measurements across pump termi-
nals. Measurements should be as shown
in the wiring diagram.
If winding measurements are much
higher (tens of ohms to infinity) than
shown in wiring diagram, replace the
pump motor.
If the resistance at the pump motor is
correct, there is an open circuit in the
wiring between the motor and the ma-
chine/motor control. Repair or replace
the lower wiring harness.
If the pump motor windings and ma-
chine/motor control check OK, repair
or replace the pump. Be sure to check
the pump and tub sump for foreign ob-
jects before replacing pump.
7. See Activation of Manual Diagnostic Test
Mode, and perform the Manual: Pumps
test.
8. If the Manual: Pumps test failed, then the
machine/motor control has failed:
Unplug the washer or disconnect power.
Replace the machine/motor control as-
sembly.
Perform the Manual: Pump test.
TEST #8 Door Lid Lock
Perform the following checks if washer fails to
lock (or unlock).
1. Perform Manual: Door Switch and Manu-
al: Door Lid Lock tests.
2. Remove the console to access the ma-
chine/motor control assembly. See Ac-
cessing & Removing the Electronic As-
semblies.
3. Visually check that the P12 connector is
inserted all the way into the machine/mo-
tor control.
If visual check passes, go to step 4.
If visual check fails, reconnect P4 and
repeat step 1
.
•
•
•
•
•
•
•
•