39
3.
Lift the fill lid and flush interior thoroughly with warm water.
4.
Allow to air dry.
Non-Use and Vacation Care
Operate your machine only when you are home. If moving or not
using your machine for a period of time, follow these steps:
1.
Unplug or disconnect power to machine.
2.
Turn off water supply to machine to avoid flooding due to
water pressure surges.
HELPFUL TIP:
Attach a reminder note to the machine to
turn the water back on before machine’s next use.
3.
Clean the dispensers. See “Cleaning the Dispensers.”
Winter Storage Care
IMPORTANT:
To avoid damage, install and store machine where
it will not freeze. Because some water may stay in hoses, freezing
can damage machine. If storing or moving during freezing
weather, winterize your machine.
To winterize machine:
1.
Shut off both water faucets; then disconnect and drain
water inlet hoses.
HELPFUL TIP:
Attach a reminder note to the machine to
turn the water back on before machine’s next use.
2.
Put 1 quart (1 L) of R.V.-type antifreeze in machine drum
and run machine on Normal cycle for about 2 minutes to
mix antifreeze and remaining water.
3.
Unplug machine or disconnect power.
Transporting your All-In-One Washer Dryer
1.
Shut off both water faucets. Disconnect and drain water
inlet hoses.
2.
If machine will be moved during freezing weather, follow
“Winter Storage Care” directions before moving.
3.
Disconnect drain hose from drain system and from back of
machine.
4.
Unplug power cord.
5.
Place inlet hoses and drain hose inside machine drum.
6.
Bundle power cord with a rubber band or cable tie to keep
it from hanging to the ground.
IMPORTANT:
Call for service to install new transport bolts.
Do not reuse transport bolts. Machine must be transported
in the upright position. To avoid structural damage to your
machine, it must be properly set up for relocation by a
certified technician.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Reinstalling/Using Again
To reinstall machine after non-use, vacation, winter storage, or
moving:
1.
Refer to Installation Instructions to remove transport bolts,
locate, level, and connect machine.
2.
Before using again, run machine through the following
recommended procedure:
To use machine again:
1.
Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
2.
Plug in machine or reconnect power.
3.
Run machine through Heavy Duty cycle to clean machine
and remove antifreeze, if used. Use only HE detergent.
Use half the manufacturer’s recommended amount for a
medium-size load.
Cleaning the Drain Pump Filter/Draining
Residual Water
NOTE:
Perform the following procedure occasionally.
IMPORTANT:
Make sure the machine is off before cleaning the
drain pump filter.
1.
Open the dispenser drawer by pulling on the handle at the
base of the machine. This will reveal the drain pump filter.
Remove the drawer by releasing the tab on each side. With
your finger, push down on tab on right side of drawer, and
up on tab on left side of drawer.
Left side
Right side
Содержание 8TWFC6810LW
Страница 63: ...63 NOTES ...
Страница 64: ...W11516195A 2021 年 6 月 2021保留所有權利 All rights reserved 06 21 ...
