Whirlpool 8TWFC6810LW, Инструкция по здоровью и безопасности, использованию, уходу и установке

Страница: 45 / 64

45
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until clear.
Connect inlet hoses to Machine
IMPORTANT:
To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates for
future reference.
n
Do not overtighten hose or use tape or sealants on the
valve. Damage to the valves can result.
n
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Attach hot water hose to hot water inlet valve. Screw coupling by
hand until it is snug. Use adjustable pliers to tighten couplings an
additional two-thirds turn. Repeat with cold water inlet valve.
Check for leaks
Slowly turn on water faucets to check for leaks. A small amount of
water may enter machine. It will drain later.
Secure drain hose
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie or beaded tie strap. It is the
responsibility of the installer to install and secure the drain hose
in to the provided plumbing/drain in a manner that will avoid the
drain hose coming out of or leaking from the plumbing/drain.
4.5"
(114 mm)
4.5"
(114 mm)
Laundry Tub
4.5"
(114 mm)
Standpipe
4.5"
(113 mm)
4.5"
(114 mm)
Wall
Level All-In-One Washer Dryer
IMPORTANT: Leveling your machine properly reduces excess
noise and vibration.
Check levelness of machine
Remove cardboard from beneath machine. Place a level on top
edges of machine, checking each side and front. If not level, tip
machine and adjust feet up or down as shown in “Adjust leveling
feet” and “Tighten leveling feet”, repeating as necessary.
Rock machine to test foot contact
Grip machine from top and rock back and forth, making sure all
four feet are firmly on floor. Repeat, rocking machine from side to
side. If machine rocks, adjust leveling feet. If all four feet are in firm
contact with floor, tighten leveling feet.
Adjust leveling feet
Place level here
Not Level Not Level Level
Jam nut