Whirlpool 8TWFC6810LW, Инструкция по здоровью и безопасности, использованию, уходу и установке

Страница: 37 / 64

37
ALL-IN-ONE WASHER DRYER
MAINTENANCE AND CARE
Water Inlet Hoses
Replace inlet hoses after five years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses:
Mark the date of replacement on the label with a permanent
marker.
Check that the old rubber seals on water inlet hoses are not stuck
on the machine inlet valves.
Use new washers in the new inlet hoses to ensure a proper seal.
All-In-One Washer Dryer Care
Recommendations to Help Keep Your Machine Clean and
Performing at Its Best
5. Always use High Efficiency (HE) detergents and follow the
HE detergent manufacturer’s instructions regarding the
amount of HE detergent to use. Do not use more than the
recommended amount because that may increase the rate
at which detergent and soil residue accumulate inside your
machine which, in turn, may result in undesirable odor.
6.
Use warm or hot water washes sometimes (not exclusively
cold water washes) because they do a better job of
controlling the rate at which soils and detergent accumulate.
7. Always leave the machine door slightly ajar between uses
to help dry out the machine and avoid the buildup of odor
causing residue.
8. Periodically clean residue from all interior surfaces of the
window. For better care, wipe the entire inside of the door
with a damp cloth.
Cleaning Your All-In-One Washer Dryer
Read these instructions completely before beginning the
routine cleaning processes recommended below. This machine
maintenance procedure should be performed, at a minimum, once
per month or every 30 cycles, whichever occurs sooner, to control
the rate at which soils and detergent may otherwise accumulate in
your machine. Note that since this is an all-in-one Washer Dryer
without a lint screen, you may see some more lint accumulation
on the door seal than a typical washer.
Cleaning the Door Seal
1.
Open the machine door and remove any clothing or items
from the machine.
2. Inspect the gray-colored seal between the door opening and
the drum for stained areas, soil buildup, or lint. Pull back
the seal to inspect all areas under the seal and to check for
foreign objects or lint.
3.
If stained areas, soil buildup, or lint are found, wipe down
these areas of the seal using either of the following two
procedures:
a.
Affresh
®
Machine Cleaning Wipes Procedure:
i.
When the cycle is complete, gently pull back the
rubber door seal and clean the entire surface with
the textured side of an affresh
®
Machine Cleaning
Wipe.
b.
Dilute Liquid Chlorine Bleach Procedure:
i.
Mix a dilute bleach solution, using 3/4 cup (177 mL)
of liquid chlorine bleach and 1 gallon (3.8 L) of warm
tap water.
ii.
Wipe the seal area with the dilute solution, using a
damp cloth.
iii.
Let stand for 5 minutes.
iv.
Wipe down area thoroughly with a dry cloth and let
machine interior air dry with door open.
IMPORTANT:
n
Wear rubber gloves when cleaning with bleach.
n
Refer to the bleach manufacturer’s instructions for proper
use.
Cleaning the Inside of the All-In-One Washer Dryer
This machine has a special cycle that uses higher water volumes
in combination with affresh
®
Washer Cleaner or regular liquid
chlorine bleach to thoroughly clean the inside of the machine.
Steam models also utilize steam to enhance cleaning in this
special cycle.
IMPORTANT:
Do not use thickened, easy-pour, or no-splash
bleach when running the Clean Washer with affresh
®
cycle as
excess suds may occur.
NOTE:
Read these instructions completely before beginning the
cleaning process.
Begin procedure
1.
Clean Washer with affresh
®
Cycle Procedure
(Recommended for best performance):
a.
Open the machine door and remove any clothing or
items
.
b.
Use an affresh
®
Machine Cleaning Wipe or a soft, damp
cloth or sponge to clean the inside door window.
c.
Add an affresh
®
Washer Cleaner tablet to the machine
drum.
d.
Do not add the affresh
®
Washer Cleaner tablet to the
dispenser drawer.
e.
Do not add any detergent or other chemical to the
machine when following this procedure.
f.
Close the machine door.
g.
Select the Clean Washer with affresh
®
cycle.
h.
Select the FanFresh
®
option to help dry the machine
interior after the cycle is complete.
NOTE: The machine remembers your last option
selection and will use it for future wash cycles until you
deselect that option.
i.
Touch and hold START/PAUSE to begin the cycle. The
Clean Washer with affresh
®
cycle operation is described
below.
2. Chlorine Bleach Procedure:
a.
Open the machine door and remove any clothing or
items.
b.
Open the single load dispenser drawer and add
regular liquid chlorine bleach to the “MAX” line in
both the bleach compartment and the fabric softener
compartment. Either traditional or HE chlorine bleach
can be used.
IMPORTANT: Do not use thickened, easy-pour, or no
splash bleach as excess suds may occur.
NOTE:
Use of more liquid chlorine bleach than is
recommended above could cause machine damage
over time.
c.
Close the machine door and the dispenser drawer.
d.
Do not add any detergent or other chemicals to the
machine when following this procedure.
e.
Select the Clean Washer with affresh
®
cycle.
f.
Select the FanFresh
®
option to help dry the machine
interior after the cycle is complete.
NOTE:
The machine remembers your last option
selection and will use it for future wash cycles until you
deselect that option.
g.
Touch and hold START/PAUSE to begin the cycle. The
Clean Washer with affresh
®
cycle operation is described
below.
NOTE: For best results, do not interrupt cycle.