Wheatstone Corporation AUDIOARTS ENGINEERING DMX Series, Руководство пользователя

Страница: 34 / 63

34
previous Salvo are removed so you have a clean slate. As soon as you
make the first
connection “(empty)” is removed from the name indicating
that Salvo is in-use. There ’ s no Save Salvo button since the active Salvo is
updated with every edit.
When you select a Salvo in the drop-down list, its connections are shown
in the Salvo Edit Screen in read-only mode. The Details Dock also lists
that Salvo’s connections by their destination and source signal numbers
and names. If you want to make changes, click the Editable button, then
you can add or remove crosspoints.
To take a Salvo, select it from the drop-down list then click Fire . The
crosspoints assigned in the Salvo are all immediately connected — except
for any connection going to a locked destination, like channels that are
turned on. To make those connections, turn off the channel(s) or unlock
locked destinations, then fire the Salvo again. You can also assign the Soft
button, in the monitor section of the DMX Surface, or a button on a
programmable button panel, to fire a salvo.
Info Tab
This tab (Figure 3-17) has three sections, highlighted, which may need
to be checked and/or set. In the Set Date and Time section check Use
this PC’s time then click Apply to update the date and time on the monitor
OLED displays to that PC’s date and time . If the PC running Navigator is
also connected to the Internet (using a separate NIC), click the NTP radio
button then select a remote time server to keep the system time
synchronized.
Note: If the Mix Engine is power cycled, or the Surface is
rebooted, the date and time must be manually updated again.
In the Clock Master Info section, check that the Clock Master
Frequency is properly set. The default setting is 44.1, but this can be
changed to 48 kHz (needed by some audio playback systems) by clicking
the 48 kHz radio button.
If there are any Razor Interfaces in the system, the Blade Display
Settings section is used to control the brightness of the front panel OLED
display. There is no Screen Saver on the Razor so that setting is not
applicable to a Razor, but the Brightness , Dim Brightness , and Screen Dim
are set like setting up the OLED displays on the DMX Surface Setup app.
The remaining sections on this tab are not applicable to a stand-alone
DMX. Refer to the WheatNet-IP System User Manual about the other
settings on this tab.
Figure 3-17 Info Tab
LIO Properties Tab
This tab (Figure 3-18) can be used to set the unconnected state
condition for the User-defined logic functions (User 1 – User 500). Each
User-defined logic function can be set so its unconnected state is High,
Low, or leave it in its Last State when disconnected. The default setting is
Low . This tab also shows the unconnected state settings for the pre-
assigned logic functions, but none of those settings can be edited.
Figure 3-18 LIO Properties Tab