Western LOW-PRO 300W, Руководство механика

Страница: 17 / 106

Lit. No. 72131, Rev. 00 July 15, 2018
15
Excerpts taken from Striker™ Stainless Steel Hopper Spreader Owner's Manual (Lit. No. 99584, Rev. 02).
OPERATING THE HOPPER SPREADER – CAB CONTROL
Error Codes
–
Spreader Operation Stopped
Code De fi nition Possible Cause Suggested Solution
EF Excessive drive faults. Too many HO and/or SO error codes;
hopper module overheating.
Control times out for 60 seconds.
Ensure that conveyor and/or spinner are not jammed.
HO Hopper overload – software trip. Drive system has high current.
Material is jammed.
Chain is damaged. Inspect conveyor; clear material jam, or fi x chain as needed.
HO . Hopper overload – hardware trip.
HP Hopper power issue.
No motor present. Hopper drive motor is not connected.
Possible motor defect. Check connections to the conveyor drive motor (P—FEED and GND posts on the
module and studs on the motor).
Replace the motor.
Lb Low battery. Hopper module is
sensing ≤ 6V.
Bad connection or low battery.
Snowplow or other vehicle power use may
be driving down voltage.
Voltage is measured at the hopper module, so Lb code may indicate cable voltage
loss. Check battery, alternator, and connections.
OH Overheating. Spreader module is too hot.
Spreader module malfunction.
Accessories wiring/function problem.
Drive motor overload. Allow a cool-off period of 60 seconds or longer.
Check for loose harness connections.
Check accessory connections. Check integrity of accessory wiring and harness.
Clear jammed material.
Contact authorized dealer.
OH . Overheating module –
microprocessor.
rS Reset of spreader module. Power loss to module detected on startup. Reset the control by pressing the ON/OFF button. Check vehicle harness and
battery connections.
SO Spinner drive overload –
software trip.
Material jammed in chute.
Spinner shaft is damaged.
Drive belt is misaligned. Inspect spinner and spinner drive components for alignment and condition. Check
for damage to bearings, belts, shafts, and sprockets.
Adjust and replace parts as required.
SO . Spinner drive overload –
hardware trip.
SP Spinner power issue.
No motor present. Spinner drive motor is not connected.
Possible motor defect. Check connections to the motor (SPIN and GND posts on the module).
Replace the motor.
Cab Control Codes, continued