Western LOW-PRO 300W, Руководство механика

Страница: 69 / 106

Lit. No. 72131, Rev. 00 July 15, 2018
67
Changing from Short Chute to Long
Chute Con
fi guration − Hydraulic Models
1. Disconnect the chute hydraulic hoses.
2. Remove chute from spreader if installed.
3. Loosen the set screws on the lower bearing
collar.
4. Remove and retain the coupling pin from the
top of the spinner shaft.
5. Remove and retain the four fasteners that
attach the upper and lower sections together.
6. Open the shaft extension kit and inventory the
parts in the kit (middle section, long spinner
shaft, bolt bag).
7. Attach the middle section to the lower section
using four 3/8"-16 x 3/4" cap screws, 3/8" nuts,
3/8" lock washers, 3/8"
fl at washers, and two
1/4"-20 x 3/4" cap screws, four 1/4" fl at
washers, and two 1/4"-20 locknuts.
8. Attach the middle section to the upper section
using four 3/8"-16 x 3/4" cap screws, 3/8" nuts,
3/8" lock washers, and 3/8"
fl at washers.
9. Install the long shaft up through the lower
bearing and spinner, and into the hydraulic
motor coupling. Pin the shaft to the coupling
using the retained pin.
10. Tighten the lower bearing set screws.
11. Reinstall the spinner bolt.
12. Con fi rm that the spinner shaft spins freely.
13. Reinstall the chute on the spreader.
STEEL HOPPER SPREADERS – CHUTE LENGTH ADJUSTMENT: HYDRAULIC MODELS