User Guide
3. Support
3.7 CMA Replacement
c.
Team-lift the enclosure until the inner rails (which are attached to the chassis) align with the
extended mid-rails (which are attached to the rack), and guide the inner rails on the chassis
to mate with the rack rails.
Figure 88:
Installing the Chassis
d.
Once the rails are mated properly, slide the enclosure into the rack until it is stopped by the
safety catch on the rails. Push the release lever on the safety latch (located on the side of
each of the rails), and push the enclosure the rest of the way into the rack.
Figure 89:
Safety Latch Release
e.
As the chassis is slid into the rack, position one installer at the rear of the rack to ensure that
the pegs on the sides of the cover will slide correctly into the rear cover alignment brackets
on both sides of the rack. If the chassis does not install smoothly or snags, check that the
rear cover alignment brackets are not interfering with the chassis sidewalls, and try again.
Step 14 :
Install the CMA(s).
92
Содержание 1EX1231
Страница 1: ...User Guide Ultrastar Data102 Regulatory Model H4102 J Document D018 000226 000 Revision 04 May 2022...
Страница 16: ...User Guide Points of Contact xv...
Страница 110: ...User Guide 3 Support 3 7 CMA Replacement Figure 91 CMA Cable Routing c Open all of the baskets Figure 92 Open Baskets 94...
