11
English
3. Advice for user:
The system display some information
Advice displayed
Explication
Solution
Time fix: XXX s
At the end of a fix while user don’t
Relase screw driver lever or external
RELASE LEVER
release lever, is possible to see the
signal of lever.
fix time, useful to set min and max
time in menu.
Under min time
Indicate an error about a fixage
If for you the fixage is correct, reduce
complete under minimum time
min time into menu
Over max time
The fixage is not stopped by torque
If for you the fixage is correct, incrase
but because the fix time is going over
max time into menu
max time setted on menu
Speed set not reached
Screw driver fix a screw under
Probably the screw was too fix, defix a
nominal speed.A motor required
bit and fix again or incrase the torque
some time to arrive at the speed set.
set into menu
A fixage into this time is considered wrong
Torque on ramp phase
The screw is fix during ramp phase setted
Probably the screw was too fix, defix a
into menu, therefore it need to reduce the
bit and fix again or reduce ramp
percentage of ramp
percentage into menu
Under break time
When is set an hard joint and the screw is
Probably the screw was too fix, defix a
fixed under break time the fix is wrong
bit and fix again or decrase break
because the fixage speed is wrong
time into menu
Reverse phase not finish
If speed set is not OFF, after a correct fix
If the defix time is too long reduce
the system automatically refix the screw.
revers time into menu or deactive
If user relase lever the system stop the
defix, but if is not finish it is an error.
Protection mode activated
If screw driver controller is out of control for
Probably the speed set is too low for
a fixage problem, the unit automatically stop the torque set. Reduce the torque
screw driver and show you this message
or incrase the speed
Stop motor active
In the rear of the unit there is an external
Relase external contact of stop motor
contact that stop screw driver and all
function of display until user don't relase this
Saving please wait
The system is saving the data changed,
Wait until save is finish
therefore don't turn off the unit during this time
Unusable with clutch driver
Into menu some choice is not possible
If you aren't using a model with clutch
because with some model of screw driver
change choice number 1 into menu to
not function, for example a torque
your correct screw driver
percentage regulation don't work with
clutch model because torque regulation
is mechanically to the screw driver
Not usable in hard mode
When user is using an electronic screw
If you need this function change
driver (not with cluch) if select hard joint
selection number 4 of menu
some regulation (like speed) is automatically from soft to hard
set, other regulation (like ramp phase) is not usable
