Welbilt Lincoln Impinger 1600 Series, Международное руководство по обслуживанию

Страница: 43 / 52

Document #: LIN_GO_SM_IMPLOPRO_S1600_INTL_4605727 – 9/20
Section 8
Charts
Specifications – Models with Gas Heat
Electrical Service – All Models with Gas Heat
Voltage (AC) Phase
50/60 Hz Ovens 220/230 1
Notice
Do not install the (these) oven(s) in any area with an
ambient temperature in excess of 95°F/35°C. Doing so
will cause damage to the unit(s).
SPECIFICATIONS
BODY: Stainless Steel (Exterior except back panels)
POWER: Gas
DB LEVEL: ≤77 dba
OPERATING TEMPERATURE RANGE: 250° - 600°F
(121° - 316°C)
Gas Ovens
Model* Energy Power Voltage Current Phase Hz
Recommended
Electrical Specification
Gas Manifold
Pressure**
1631-xxx-X-Kxxxx G20 32 kW (HI) 3.35 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1631-xxx-X-Kxxxx G25 26.5 kW (HI) 3.18 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1631-xxx-X-Kxxxx G25.3 26.5 kW (HI) 3.22 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1632-xxx-X-Kxxxx G30 37 kW (HI) 1.16 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 24.8 mB
1632-xxx-X-Kxxxx G31 33.2 kW (HI) 1.33 m 3 /hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 24.8 mB
1633-xxx-X-Kxxxx G20 31.3 kW (HI) 3.31 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1633-xxx-X-Kxxxx G25 25.7 kW (HI) 3.0 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1633-xxx-X-Kxxxx G25.3 25.4 kW (HI) 2.97 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 8.7 mB
1634-xxx-X-Kxxxx G30 34.2 kW (HI) 1.06 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 24.8 mB
1634-xxx-X-Kxxxx G31 30.9 kW (HI) 1.26 m
3
/hr 230 VAC 4 Amps 1 50 Hz 3 Wires, 1 Pole 1N-1G 24.8 mB
1635-xxx-X-Kxxxx Nat. Gas 110,000 BTU/hr 220 VAC 4 Amps 1 60 Hz 3 Wires, 1 Pole 1N-1G 0.87 kPa
1636-xxx-X-Kxxxx LP Gas 110,000 BTU/hr 220 VAC 4 Amps 1 60 Hz 3 Wires, 1 Pole 1N-1G 0.87 kPa
* Reference Model Number Key, Section 1.
Gas Pressure Conversion Chart
Inches of Water
Column
kPa m-Bar
Millimeters of
Water Column
3.5 0.87 8.7 88.9
4.5 1.12 11.2 114.3
7 1.74 17.4 177.8
10 2.48 24.87 254.0
10.5 2.61 26.11 266.7
11 2.73 27.36 279.4
14 3.48 34.81 355.6
14.5 3.61 36.05 368.3
Electrical Supply for Gas 1600 Ovens in Australia:
Single Phase: 240 VAC, 50 Hz / 20 Amp: one neutral and
one earth/ground.
NOTE: In Australia, use a 10 Amp General Purpose Outlet.
All ovens require separate service and decidated neutral.
NOTE: For proper operation, the gas valve requires a
nominal inlet pressure of 7 inches H
2
O column for natural
gas and 11 inches of H
2
O column for L.P. gas. A minimum
inlet pressure of 1.0 inch of H
2
O above the manifold setting
(NAT. manifold 3.5 inch H
2
O, L.P. manifold 10 inch H
2
O) must
be maintained with no pressure drop from the no load to
full load condition. The maximum inlet pressure must be
maintained at or below 1/2 psig (14.5 inches H
2
O column).
Refer to the chart on the left for pressure conversions.