Welbilt Lincoln Impinger 1600 Series, Международное руководство по обслуживанию

Страница: 17 / 52

Document #: LIN_GO_SM_IMPLOPRO_S1600_INTL_4605727 – 9/20
Section 2 Installation
7. Before installing the finger supports in the oven(s), be
sure all of the packing materials are removed from the
plenum shroud.
Install air return baffles (1), if provided.
Install the finger supports by hooking the rear retaining
pin (2) and swinging the finger support into position (3)
as shown above.
8. Assemble fingers as shown below.
9. Insert columnating plate so the step goes under the lip
of the finger housing and the plate lies flush with the
housing side edge.
10. Install cover by sliding it on the small end of the finger
housing.
11. Insert assembled finger through door opening, starting
with lower left. NOTE: The customer MUST tell you
which position to place the assembled finger in for
their application.
12. Install the finger in the oven by sliding it over the
plenum flange and setting the front bracket. BE SURE
THAT THE FINGER SITS SQUARELY OVER THE PLENUM
FLANGES AND THE HOLES POINT IN THE PROPER
DIRECTION. Top fingers point down, bottom fingers
point up.
13. Repeat step 12 until all eight (8) fingers are installed.