Welbilt Lincoln Impinger 1600 Series, Международное руководство по обслуживанию

Страница: 23 / 52

Document #: LIN_GO_SM_IMPLOPRO_S1600_INTL_4605727 – 9/20
Section 4 Maintenance
16. Reinstall the conveyor. Insert the conveyor through the
opening in the right side. Sprocket will be to the right
side of the conveyor.
Conveyor Drive Sprocket
Drive Motor
Sprocket
1/2" Sag
Drive Chain
Conveyor Drive Sprocket
Drive Motor Sprocket
17. Slide conveyor through the oven chamber until
the locking bar on the drive end of the conveyor is
approximately 2” – 3” (50 – 76 mm) into the oven
chamber. Install drive chain by placing it over the drive
sprocket and placing it over the conveyor sprocket
(Split Belt models have two drive chains and sprockets).
18. Lift conveyor just enough to allow you to pull the
conveyor toward you until the locking bar is outside of
the oven cavity. At the same time, push the conveyor
downward so that the bar locks on the outside of the
oven wall.
19. Inspect sprocket alignment and adjust if necessary.
20. Reinstall conveyor crumb pans and chain guard cover.
21. Clean any dirt from the louvers, on the control box
cooling fan, and openings on the rear wall (cover).
22. Reapply power.
Safety - Folding Conveyor Option (Non
Standard Special Order)
The following safety notice pertains to ovens that have the
folding conveyor option.
n
Warning
Folding conveyors have a “pinch point” in the center
section of the assembly. Always keep hands away from
the center section of the folding conveyor. Failure to do
so could result in serious injury!
Top View of Conveyor Assembly