11
AGITATOR
To remove and clean agitator
(two-person job):
1.
Remove scraper blades.
2.
Rotate agitator until pull pin is on top side.
3.
Turn power OFF.
4.
Pull pin out.
5.
Slide coupling toward kettle wall, and carefully lift
agitator pulling back to lift out.
6.
Clean in a sink, using a warm water and mild
detergent solution.
7.
Rinse with fresh water.
Agitator shaft
Pin
Coupling
FLUSH PISTON VALVE
Daily
- clean valve as follows:
1.
Open product valve.
2.
Disconnect air hoses.
3.
Remove air cylinder.
4.
Remove valve tee.
5.
Remove all O-rings.
6.
Clean air cylinder, do not submerge in water. Wipe
clean and sanitize.
7.
Clean and sanitize tee and O-rings.
8.
Grease and reinstall O-rings.
9.
Reinstall tee to kettle outlet.
10.
Reinstall air cylinder to bottom of tee.
11.
Reconnect air hoses.
12.
Close valve and check for alignment.
AIR HOSE
AIR
CYLINDER
AIR HOSE
OPEN
POSITION
CLOSED
POSTITION
O-RING
CLAMP
O-RING
VALVE
TEE
O-RING
CLAMP
KETTLE
OUTLET
KETTLE
AGITATOR BUSHING
With agitator out, remove bushing by:
1.
Remove bushing by turning 1/4 turn and pulling away
from the kettle wall.
2.
Clean, rinse and sanitize bushing and bushing
mounting area.
3.
Lubricate metal surfaces with food safe grease.
4.
Install bushing by locating retaining pin and sliding
bushing on.
5.
Rotate to lock into position.
S
lot
B
us
hing
Ret
a
ining
Pin
Agit
a
tor
S
h
a
ft
Iddler
Pin
Содержание CLEVELAND HA-MKGL-100
