WEGER WALTER GMBH DIWER EVO DP80 Series, Инструкция по установке и эксплуатации

Страница: 32 / 64

Installation and Operating Manual Page
30
Printed: 02/2015
Pre-assembled panels must always be removed in order to ensure that they are properly
positioned and that the seals are in place. After you have established that the seal is in its
correct position, install and secure the panels on all sides with the supplied clamping bars.
Please note that pre-assembled units or unit sections must be dismantled and fully assembled
by specially trained technical personnel.
For the dismantling and assembly of pre-assembled units and unit sections, observe the
following instructions:
- During dismantling, all unit components must be properly labelled to ensure that they
can be installed in the correct position.
CAUTION
All unit sections with coolers, humidifiers of any type and other built-in components that might
be affected by condensation or exposed to other liquids must be carefully sealed from the
inside.
All panels must be secured on all sides with the supplied clamping bars.
PRE-ASSEMBLED READY FOR OPERATION
WEGER shall not be liable for damage caused by incorrect or incomplete assembly of pre-
assembled units or unit elements.