WEGER WALTER GMBH DIWER EVO DP80 Series, Инструкция по установке и эксплуатации

Страница: 28 / 64

Installation and Operating Manual Page
26
Printed: 02/2015
5.3.2. Connection of unit sections from the inside with internal brackets
In large units, the sections must also be connected to each other by means of internal brackets
mounted at the side. In large units, the sections must also be connected to each other by
means of internal brackets mounted around the unit, at the sides, top and base of the
sections. Install 2 brackets per connection and secure them with screws
(A) to the unit frame.
Tighten the screws (B) to pull the unit sections together.
Number and position of connections per unit side
5.3.3. Roof joint connections for outdoor units
Clean and degrease the roof joining points. Then:
a Seal the connecting points above and below the holes with putty.
b Connect the joining parts with the supplied screws (see figure).
c Cover the joints with the supplied strips and secure them with rivets.
c1 Alternatively, bend back the edges c2 .
b
a
c
2
c
1