WEGER WALTER GMBH DIWER EVO DP80 Series, Инструкция по установке и эксплуатации

Страница: 31 / 64

Installation and Operating Manual Page
29
Printed: 02/2015
1
2
3
4
5.5. Dismantling of panels and panelling profiles
1. Using a chisel, lever out the clamping bar and remove the panel.
Do not damage the clamping bar!
2. Move the clamping blocks by approx. 35 mm to the side.
3. Loosen the screw.
4. The panelling profile can now be removed.
5.6. Dismantling of frame profiles
To remove the frame profiles, please proceed as shown in the figure below.
5.7. Pre-assembled units
In units or unit sections that are equipped with plastic clamping pieces (each approx. 30 cm
long) instead of clamping bars, the panels are only pre-assembled and the actual clamping bars
are supplied separately with the unit. This option is chosen in the following cases:
- The customer has ordered units or unit elements as pre-assembled units, as these units
are larger than the access opening on site. The customer can thus disassemble the unit on
site, transport the sections to the installation site and reassemble the unit.
- If certain connecting points between individual unit sections are no longer accessible,
although they need to be screwed together from the inside, the adjacent panels are only
pre-assembled so that they can be easily removed to make the connections.
Subsequently, the panels must be permanently installed.