Chapter 7
Adjustment and initial operation
32708885 Geset 100
Version: 16.07.13
Page 45 of 77
GB
Information on adjustment of pushing plate
Depending on product and label, the pushing plate has to be selected and adjusted. The
pushing plate should include the product appr. 5 mm deeply.
Requirements
¥
Power supply is turned off.
¥
One or more sample products.
¥
No transportation of products.
Instruction
Please adjust the pushing plate as follows.
Step
Procedure
1
Install the pushing plate that is suitable for the product.
2
Adjust the pushing plate (Fig. 7-7: Pos. 2) at the positioning device (Fig. 7-7:
Pos.1) to the height of the label position and to the product width. When
adjusting the product width, the product should get as deeply in the pushing
plate (appr. 5 mm), that the label is safely pushed onto the prduct.
3
Check and correct this adjustment if necessary.
Information on adjustment of wrapping unit
Depending on product and label, the wrapping unit has to be adjusted in height.
Requirements
¥
Power supply is turned off.
¥
One or more sample products.
¥
No transportation of products.
Instruction
Please adjust the wrapping unit as follows.
Step
Procedure
Crushing hazard!
When loosening the clamping device, the wrapping unit lowers in direction
to the base conveyor.
-
Maintain a distance from wrapping unit and base conveyor.
1
The wrapping unit has to be supported by a suitable device to avoid a lo-
wering from wrapping unit to base conveyor.
2
Loosen carefully the interlock (clamping device Pos. 10 Fig. 7-7).
3
Lift the wrapping unit, remove the supporting device and place the wrapping
unit to the product’s height.
4
Tighten the interlock (clamping device Pos.10 Fig. 7-7) again.
5
Check and correct this adjustment if applicable.
Содержание Geset 100
Страница 2: ...Blank page ...