7540 CR 201, PO Box 68 • Mt. Hope, OH 44660-0068 • 800-932-8371 or 330-674-1782
Please call us with any product questions or for technical assistance.
23
You’ll need to pre-punch a 3/16" hole in your material to accommo-
date the stem of the 4P Durable Snap. Please note: The top of snap
always has the nice cap that is to be placed on the finished side of the
leather. Take a few minutes to check all your components to ensure
they will snap the way you desire for your project. To achieve the best
results, we recommend testing a few snaps in some scrap leather.
FIGURE 101
FIGURE 107
FIGURE 102
FIGURE 108
FIGURE 104
FIGURE 110
FIGURE 105
FIGURE 106
FIGURE 111
FRONT VIEW
BACK VIEW
FIGURE 112
Setting 4P (#24 Line) Durable Snaps
FIGURE 103
FIGURE 109
1B
1
2
3
4
1T
2T
2B
3) For bottom of snap, insert the 2B anvil into the anvil
adapter and secure with the set screw using a 5/32"
Allen wrench
(Figure 107)
. Adjust the driver up by
turning adjustment wheel clockwise or down by
turning counter clockwise
(Figure 108)
. Insert the 2T
driver into the driver shaft and secure with the thumb
screw
(Figure 109)
.
4) Place hardware component 4 into the 2B anvil
(Figure 110)
and hardware component 3 into the
2T driver
(Figure 111)
. Insert leather or material using.
Pull the handle forward until set
(Figure 112)
.
5) Snap it to verify that all the components are placed so
they snap correctly for your project.
1) For top of snap, insert the 1B anvil into the anvil adapter and secure
with the set screw using a 5/32" Allen wrench
(Figure 101)
. Adjust
the driver up by turning adjustment wheel clockwise or down by
turning counterclockwise
(Figure 102)
. Insert the 1T driver into the
driver shaft and secure with the thumb screw
(Figure 103)
.
2) Place hardware component 1 into the 1B anvil
(Figure 104)
and
hardware component 2 into the 1T driver
(Figure 105)
. Insert leath-
er or material using. Pull the handle forward until set
(Figure 106)
.
Will not work
with locking snaps
