7540 CR 201, PO Box 68 • Mt. Hope, OH 44660-0068 • 800-932-8371 or 330-674-1782
Please call us with any product questions or for technical assistance.
19
FIGURE 62
FIGURE 63
FIGURE 65
FIGURE 66
FIGURE 64
FOR SETTING STAPLES
WITH THE LOOP ANVIL
1) Insert the loop anvil into the anvil adapter and secure the anvil
with the set screw located at the front of the anvil adapter using
a 5/32" Allen wrench
(Figure 62)
. To give yourself room to see
the loop anvil clearly, you’ll need to raise the driver by turning
the adjustment wheel clockwise
(Figure 63)
. To lower the driver,
turn the adjustment wheel counterclockwise. Insert the slide loop
staple setter attachment into the driver shaft and secure with the
thumb screw
(Figure 64)
.
2) Place the staple into the setter
(Figure 65)
.
3) Insert leather or material that you are using.
4) Pull the handle forward until staple is set
(Figure 66)
.
FIGURE 67
FIGURE 68
FIGURE 69
USING THE METAL GUIDE
A metal guide
(Figure 67)
is included
with the Little Wonder
®
to help you
maintain consistency when using Little
Wonder
®
attachments. Loosen the thumb
screw on the right side of the machine
and adjust guide until it rests on the edge
of your strap
(Figure 68)
. Tighten thumb
screw to keep guide in place
(Figure 69)
.
FIGURE 70
The staple sould be seated just slightly into
leather with the prongs curled in on the
underside of leather. A marred staple means
too much pressure was applied, so the staple
setter attachment will need to be raised by
turning the adjustment wheel clockwise. Turn
the adjustment wheel counterclockwise for
a loose staple with the prongs not curled in
properly
(Figure 70)
.
CORRECT
