www.weaverleathercraft.com
12
You do not need to pre-punch holes in your material to set
5/16" crystals. To achieve the best results, we recommend
testing a few crystals in some scrap leather using the
troubleshooting tips on page 13 as your guide.
1) Insert the anvil into the anvil adapter and secure with the set
screw using a 5/32" Allen wrench
(Figure 31)
. Insert the crystal
setter attachment into the driver shaft and secure with the thumb
screw
(Figure 32)
.
2) It is important to obtain the proper distance between the anvil and the
driver. Turn clockwise to raise the driver or counterclockwise to lower
the driver
(Figure 33)
.
3) Place the crystal into the driver
(Figure 34)
.
4) Insert leather or material that you are using.
5) To set the crystal, pull the handle forward until you start to feel
resistance
(Figure 35)
. Crystals will set without applying much
pressure. You can always go back and apply a bit more
pressure if necessary.
FIGURE 31
FIGURE 32
FIGURE 34
FIGURE 35
FIGURE 36
FIGURE 37
FIGURE 38
USING THE METAL GUIDE
A metal guide
(Figure 36)
is included
with the Little Wonder
®
to help you
maintain consistency when using Little
Wonder
®
attachments. Loosen the thumb
screw on the right side of the machine
and adjust guide until it rests on the edge
of your strap
(Figure 37)
. Tighten thumb
screw to keep guide in place
(Figure 38)
.
Setting Crystals
FIGURE 33
