www.weaverleathercraft.com
10
SPLASH SET RIVET
CAP SET RIVET
Magnetic driver works with plated rivets only. It does not work with
stainless steel, nickel brass or solid brass rivets.
You do not need to pre-punch holes in your material to set tubular
rivets. To achieve the best results, we recommend testing a few
rivets in some scrap leather using the troubleshooting tips on page 11
as your guide.
1) Insert the #104 magnetic driver into the driver shaft and secure with
the thumb screw
(Figure 21)
. Insert the #104 splash anvil or #104 cap
anvil (depending on if you want your rivet with a splash or cap back)
into the anvil adapter and secure with the set screw using a 5/32" Allen
wrench
(Figure 22)
.
2) It is important, especially when using caps, to obtain the proper
distance between the anvil and the driver. Adjust the stop according to
the length of the post on your rivet using the adjustment wheel located
just below the cam
(Figure 23)
. Turn clockwise to raise the driver or
counterclockwise to lower the driver.
3) Place the #104 rivet into the driver
(Figure 24)
. If using cap,
place the cap into the cap anvil flat side down
(Figure 25)
.
4) Insert leather or material that you are using.
5) Pull the handle forward until rivet is set
(Figure 26)
.
FIGURE 21
FIGURE 22 - SPLASH ANVIL
FIGURE 22 - CAP ANVIL
FIGURE 25
FIGURE 24
FIGURE 23
FIGURE 26
Setting #104 Tubular Rivets with Magnetic Driver
FIGURE 27
FIGURE 28
FIGURE 29
USING THE METAL GUIDE
A metal guide
(Figure 27)
is included
with the Little Wonder
®
to help you
maintain consistency when using Little
Wonder
®
attachments. Loosen the thumb
screw on the right side of the machine
and adjust guide until it rests on the edge
of your strap
(Figure 28)
. Tighten thumb
screw to keep guide in place
(Figure 29)
.
SPLASH
ANVIL
CAP
ANVIL
