7540 CR 201, PO Box 68 • Mt. Hope, OH 44660-0068 • 800-932-8371 or 330-674-1782
Please call us with any product questions or for technical assistance.
21
You’ll need to pre-punch holes (3/16" for top of snap; 1/8" for
bottom of snap). Please note: The top of snap always has the nice
cap that is to be placed on the finished side of the leather. Take a
few minutes to check all your components to ensure they will snap
the way you desire for your project. To achieve the best results,
we recommend testing a few snaps in some scrap leather.
FIGURE 77
FIGURE 83
FIGURE 78
FIGURE 84
FIGURE 80
FIGURE 86
FIGURE 81
FIGURE 82
FIGURE 87
FRONT VIEW
BACK VIEW
FIGURE 88
Setting 2205 Segma Snaps
FIGURE 79
FIGURE 85
1T
1
2
3
4
1B
2T
2B
3) For bottom of snap, insert the 2B anvil into the anvil
adapter and secure with the set screw using a 5/32" Allen
wrench
(Figure 83)
. Adjust the driver up by turning
adjustment wheel clockwise or down by turning counter-
clockwise
(Figure 84)
. Insert the 2T driver into the driver
shaft and secure with the thumb screw
(Figure 85)
.
4) Place hardware component 4 into the 2B anvil
(Figure 86)
and hardware component 3 into the 2T driver
(Figure 87)
.
Insert leather or material using. Pull the handle forward
until set. Be sure to not apply too much pressure
(Figure 88)
.
5) Snap it to verify that all the components are placed so
they snap correctly for your project.
1) For top of snap, insert the 1B anvil into the anvil adapter and secure
with the set screw using a 5/32" Allen wrench
(Figure 77)
. Adjust
the driver up by turning adjustment wheel clockwise or down by
turning counterclockwise
(Figure 78)
. Insert the 1T driver into the
driver shaft and secure with the thumb screw
(Figure 79)
.
2) Place hardware component 2 into the 1B anvil
(Figure 80)
and
hardware component 1 into the 1T driver
(Figure 81)
. Insert leather
or material using. Pull the handle forward until set. Be sure to not
apply too much pressure
(Figure 82)
.
