31
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at
www.wayne-dalton.com
INST
All
ATION
Side lock (Sold Separately)
Install the side lock on the second
section of the door. secure the lock to
the section with (4) 1/4”- 20 x 11/16”
self drilling screws. square the lock
assembly with the door section and
align with the square hole in the vertical
track. The side lock should be spaced
in approximately 1/8” from the section
edge.
IMPORTANT:
sIDE lOCks MusT BE
REMOVED OR MaDE INOPERaTIVE IN
ThE uNlOCkED POsITION IF aN
OPERaTOR Is INsTallED ON ThE DOOR.
NOTE:
after completing this step,
continue with step 8 on page 15.
�
(4) 1/4”- 20 x 11/16”
sElF DRIllING sCREWs
1/8”
Power Drill
7/16” socket
Driver
DoorMaster
TM
bracket/gear
(Supplied with Doormaster
™
)
NOTE:
When installing a DoorMaster
TM
operator use the center bracket and
drive gear supplied with your operator
(located in DoorMaster
TM
package).
slide the DoorMaster
TM
bracket/drive
gear assembly onto the TorqueMaster
®
spring tube, so that the drive gear/center
bracket assembly are in the center of
the TorqueMaster
®
spring tube.
NOTE:
after completing this step,
continue with step 18 on page 22.
None
�
CENTER
BRaCkET
BushING
assEMBly
TORquEMasTER
®
TuBE
A
A
DOORMasTER
TM
BRaCkET/
DRIVE GEaR assEMBly
To locate the center bracket, mark the
header halfway between the flagangles
and level the TorqueMaster
®
spring tube.
Drill 1/8” pilot holes into header for the
lag screws. Fasten the metal bracket to
the header using (2) 1/4” x 1-1/2” lag
screws.
NOTE:
after completing this step,
continue with step 27 on page 28.
b
b
Tools Needed:
Power Drill
1/8” Drill Bit
7/16” socket
Driver
(2) 1/4” x 1-1/2”
hEx hEaD laG
sCREWs
