Wavetronix Click 100, Руководство пользователя

Страница: 56 / 260

CHAPTER 7
• CLICK 101 55
Note
You will only be able to communicate properly if the Click 101 and each sensor’s RS-
485 baud rate match.
To reset the module to factory defaults, hold the push-button down for 10-15 seconds until
the red LED flashes. During the reset process, the first 12 red LEDs will light up momen-
tarily.
Computer Configuration
You must use Click Supervisor to customize the polling parameters, output mapping and
other important settings. See Chapters 4 and 5 for instructions on how to download and
install Click Supervisor and how to connect to your device using the software.
You will usually select the Expert driver to configure a Click 101. The Expert driver does not
modify Click 101 settings unless you save changes to the device. You should not connect
to your device using other drivers, unless you are sure that driver has been specifically de-
signed for your application. Other drivers may inadvertently overwrite the settings on your
module. Once you have finished configuring your device, save the settings to a backup file.
After you have made configuration changes on a driver and saved it to the Click device, the
word “current” will appear after that driver to indicate the driver that is currently loaded
onto the device.
Note
Some settings appear on multiple drivers. Changing one of those settings on any
driver and saving them to the Click device will change that setting on all other drivers.
Expert Driver
The Expert driver allows you to see all possible settings and fields, both those available in
other drivers and those available only through this driver. The driver is divided into three
tabs—
System
,
Contact Closures
and
Diagnostics
—which are then subdivided further.
The System >
General
tab allows you to change the settings affecting the setup of the device
(see Figure 7.5 and Table 7.2).