13
Load Confi guration (PnL)
LOAD CONFIGURATION (PnL)
Use the Load Confi guration function to identify
load numbers, view and change load parameters
and load bindings to sensors. You initiate Load
Confi guration (PnL) also known as Push n’ Learn™
by pointing the LMCT-100 at any IR enabled DLM
Local Network device when prompted.
Important:
To confi gure load binding from the
LMCT-100, it must be initiated by the LMCT-100. After
entering PnL you must exit before using the system.
Press
Select
Press
Select
P o i n t t o a n y I R
e n a b l e d d e v i c e o n
t h e n e t w o r k
P r e s s ‘ S e l e c t ’
S e n s o r C o n fi g u r a t i o n
L o a d C o n fi g ( P n L )
D a y l i g h t i n g C o n fi g
B u t t o n C o n fi g u r a t i o n
D i m m i n g C o n fi g u r a t i o n
M o r e
=
B AT
When the device receives the signal from the LMCT-
100, the DLM Local Network goes into PnL mode;
the red LED on all communicating devices starts
blinking at 2x/second and all loads turn OFF except
Load 1 turns ON.
Load Selection
Settings for load 1
appear fi rst.
Push
to highlight
NEXT and push the
SELECT button to turn
ON the next load and
view its settings.
Right arrow
to change
setting for
load 1
Down arrow to
highlight NEXT
then SELECT
to go to next
load
L o a d C o n fi g < P n L >
L o a d : 1
O p e r a t i o n :
< A u t o O n >
B l i n k : < D i s a b l e >
L M L S - 1 0 5 : < D i s a b l e >
S E N D B I N D N E X T E X I T
