Watts HF scientific 28052, Руководство владельца и пользователя

Страница: 20 / 67

Catalog No. 29290 13
Rev 3 06/2020
c. Using a sharp utility knife, cut the end of the tubing square.
Remove any burrs or sharp edges before inserting into fitting.
d. Place a piece of tape ½ inch from the end of the tube to indicate
how far the tube should be inserted.
e. Push the tube into the Quick-Connect fitting on the left facing side
of the MTOL+, as shown in Figure 4.
f. Check to confirm that tube is pushed fully against the tube stop.
Gently but firmly pull on the tube to check that it is secure.
g. Connect the other end of the tube to the water sample source
following proper plumbing techniques applicable to your facility and
configuration.
After completing water inlet and drain connections, check all
tubing and connections for any leaks, weeping, breaks or
defects of any kind. Repair/replace as needed.