www.enware.com.au
© Enware Pty Ltd
Page 7
Fitting the bodies:
6. Fit compression nut and olive to each side
of the copper T-piece, and fit tap bodies
on to each side. Screw each compression
nut onto each body loosely. Note: a small
groove in the spline of the spindle and red
tape indicates the hot side.
7. Check the 2 O-rings on the centre spout
fitting of the T-piece has O-ring grease
applied. Fit larger red fibre washers onto
each basin body.
8. From underneath the bench, insert the tap
bodies and T-piece assembly up through
the bench, at the same time inserting the
T-piece up into the 1/2” brass tail of spout.
Take care not to pinch or damage the
O-rings in the process. Push the T-piece
assembly until it comes to a stop. SEE
IMAGE 18.
9. While holding the T-piece up, from top of
the bench fit a clear plastic washer and a
cover dome onto each tap body. Screw
the dome in until it comes in contact with
the bench, but do not tighten the dome at
this point. Ensure both tap bodies extend
through the bench the same distance.
SEE IMAGE 19.
Now from underneath the bench, screw
the fixing nuts back up hard against the
bench and tighten with a basin spanner.
(Alternatively, from top of the bench, gently
tighten the chrome cover domes with a
spanner.)
SEE IMAGE 20 & 21
10. Now tighten the 1/2” compression
nuts on the T-piece with a spanner. Re-
torque all nuts and ensure they are tight.
IMAGE 23
11. Proceed to Fitting Lever Handles – page
12
IMAGE 18
IMAGE 19
IMAGE 21
IMAGE 23
IMAGE 20
IMAGE 22
