www.enware.com.au
© Enware Pty Ltd
Page 12
1
SPLINE
ADAPTOR
2
3
ON
OFF
ON
OFF
Wall Mounted
(front view)
ON
OFF
ON
OFF
Hob Mounted / Mixing Set
(top view)
OFF
ON
ON
Dual Mixer
(top view)
ON
OFF
Pot Filler
(front view)
4
fitting lever handles
If the lever handles do not line up
straight:
a. Change the position the spline
adaptor on the SBA spindle in
step 2.
b. Adjust position of SBA spindle
by slightly tightening or
loosening it, using a spanner on
the hex of the SBA spindle.
Note: Do not adjust position
of SBA using handle. Do not
over-tighten SBA spindle. (Max.
torque 30Nm.)
Fit handle parts back on.
c. If lever handles do not line up
parallel in the straight position, it
is recommended to offset them
away from the centre.
?
Fit colour indicator ring onto
lever handle. To do this, place
an indicator ring on flat surface with
the rebated edge facing up. Press the
lever handle down onto the indicator
ring evenly until it clips into place.
If an indicator ring needs to be
removed, place lever handle on a flat
surface and apply pressure to the
side of the indicator ring, until the ring
pops off.
Fit spline adaptor onto
spindle.
Fit tooth washer and
washer, and fix in
place using screw.
Note the orientation of the tap handle.
Fit lever handle onto spindle.
Fix the lever handle in place
with grub screw, then fit
handle plug.
Proceed to installation of
riser, pot filler & spray arm
– next page
