www.enware.com.au
© Enware Pty Ltd
Page 6
1. Mark the holes to be drilled on the bench
and drill the holes. (min. 40mm - max.
160mm to the centre from wall, tap body
centres min. 150 mm – max. 330mm.
Drill hole size: spout –
Φ
22mm, tap
bodies –
Φ
33mm).
Cut the copper T piece to size:
2. Screw 1x brass fixing nut on each tap
body and screw the nut right down to
the end of thread.
3. Fit the bodies upside down into the
33mm holes from top of the bench.
Align centre of the copper T piece to
the centre hole. Mark the copper pipes
on both sides. (19mm past the end of
the body thread, or deduct 15mm from
the centre of drilled hole on each side).
Check the measurement again, and cut
the copper tube with tube cutters. De-
burr the copper tube.
Take tap bodies out of the holes and
keep at hand.
Fit the spout:
4. Pull the brass 1/2” threaded tail off the
copper T-piece. Apply thread sealant
to the non-bevelled end of the 1/2”
threaded tail, then screw into the base of
the swivel hob and tighten. SEE IMAGE
15
5. Fit smaller clear washer through the 1/2”
tail, then fit the base onto the bench.
From underneath the bench, fit smaller
red fibre washer onto the tail, then screw
1/2” brass nut on. Note the orientation of
the grub screw on the base, then tighten
the brass nut firmly using a spanner. SEE
IMAGE 17
IMAGE 14
IMAGE 15
IMAGE 16
33
22
33
150 mm MIN - 330 mm MAX
40 mm MIN -
160 mm MAX
WALL
IMAGE 13
IMAGE 17
Maximum bench
thickness: 20mm
hob mounted concealed adjustable breech
FS013
