19
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
Install the rudder pushrod wire using the same technique as with the elevator pushrod wire. The Z-Bend should be
installed into the hole that is 1/4" out from the center of the servo horn as well.
❑
Double-check that the elevator and rudder are still centered. If they are out of adjustment, remove the clevises and
readjust them until you are satisfied with the alignment. Unplug and turn off your radio system.
❑
Kwik Bond 5 Minute Epoxy
❑
Scissors
❑
Ruler
❑
Masking Tape
❑
220 Grit Sandpaper w/Sanding Block
YOU'LL NEED THE FOLLOWING PARTS:
❑
(1) Left Wing Panel
❑
(1) Right Wing Panel
❑
(1) Decal Sheet
❑
(1) Prebent Aluminum Tube
❑
(2) Fiberglass Dowels
SECTION 11: WING ASSEMBLY & INSTALLATION
❑
(2) Double-Sided Tape - Strips
❑
(1) Plastic Wing Mount
❑
(1) Plastic Wing Brace
❑
(4) Rubber Bands
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks
❑
NHP Epoxy Mixing Cups
Step 1: Trimming the Plastic Parts
❑
Using a pair of scissors, carefully cut out around the base
of the plastic wing mount leaving about 3/16" of material
beyond the molded radius.
❑
Test-fit the wing mount onto the fuselage. To align it properly, the front edge of the wing mount should be pushed up
against the back edge of the cowling and the wing mount should be centered over the fuselage. If the edges of the wing
mount hang past the fuselage sides, trim the edges using a pair of scissors so that they are even with the fuselage sides.
❑
When satisfied with the fit, use 220 grit sandpaper with a sanding block to carefully sand the edges of the wing mount
smooth and straight.
