Waters 2489, Обзор и руководство по обслуживанию

Страница: 39 / 150

June 11, 2015, 715004752 Rev. A
Page 39
Figure 2–10: e-SAT/IN module (front panel)
2.6.7.2 Connecting the detector to the e-SAT/IN module
The e-SAT/IN module connects to the detector through the B (inputs and outputs)
terminal on the rear panel of the detector, as shown in the figure below.
To connect the detector to the e-SAT/IN module:
1. Using the electrical insulation stripping tool, strip about 3 mm (1/8 inch) from
one end of the e-SAT/IN 9-pin connector, exposing the white and black wires.
2. Connect the other end of the cable to the Channel 1 or Channel 2 connectors on
the front panel of the e-SAT/IN module.
3. For Channel 1,
• connect the white wire to pin 1 on I (Analog 1 +);
• connect the black wire to pin 3 on I (Ground).
Notice:
To avoid damaging the e-SAT/IN module (and thus void its
warranty) and to ensure its proper startup, do not power-on the module
until you perform all procedures in the Waters e-SAT/IN Module
Installation Guide .
TP02834
Power switch
LEDs
I/O connector
Analog inputs