Watchguard Firebox X15, Руководство пользователя

Страница: 74 / 266

Changing Your Network Settings
60 WatchGuard Firebox X Edge
4 Follow the instructions on the screens.
The Network Setup Wizard has these steps:
Welcome
The first screen describes the purpose of the wizard.
Configure the external interface of your Firebox
This screen asks the method your ISP uses to set your IP address.
For more information, see the subsequent section in this guide,
“Configuring the External Network.”
Configure the external interface for DHCP
If your ISP uses DHCP, type the DHCP information that your ISP
gave you. For more information, see “If your ISP uses DHCP” on
page 61.
Configure the external interface for PPPoE
If your ISP uses PPPoE, type the PPPoE information that your
ISP gave you. For more information, see “If your ISP uses PPPoE”
on page 63.
Configure the external interface with a static IP address
If your ISP uses static IP addresses, type the static IP address
information your ISP gave you. For more information, see “If
your ISP uses static IP addresses” on page 62.
Configure the trusted interface of the Firebox
On this screen, type the IP address of the trusted interface. For
more information, see “Configuring the Trusted Network” on
page 66.
The Network Setup Wizard is complete
Configuring the External Network
You must configure your Firebox® X Edge external network manu-
ally if you do not use the Network Setup Wizard.
When you configure the external network, set the method your ISP
(Internet Service Provider) uses to give you an IP address for your
Firebox. There are three methods ISPs use to assign IP addresses:
•
DHCP
- Network administrators use DHCP (Dynamic Host
Configuration Protocol) to give IP addresses to computers on
their network automatically. With DHCP, your Firebox receives
an external IP address each time it connects to the ISP network.