Watchguard Firebox X15, Руководство пользователя

Страница: 57 / 266

Restarting the Firebox
User Guide 43
Use these steps to set the Firebox to the factory default settings:
1 Disconnect the power supply.
2 Hold down the
Reset
button on the front of the Firebox.
3 Connect the power supply while you continue to hold down the
Reset button.
4
Continue to hold down the button until the yellow Attn light
comes on and stays on. This shows you that the Edge has been
successfully reset.
N
OTE
Do not try to connect to the Edge at this time. Start the Edge one
more time, as the subsequent steps show. If you do not start the
Edge one more time, when you try to connect to the Edge you will
see a web page with “Your WatchGuard Firebox X Edge is running
from a backup copy of firmware.” You could also see this message
if the reset button is stuck in the depressed position. Check the
reset button, restart the Edge and try again.
5 Disconnect the power supply.
6
Connect the power supply again.
The Power Indicator is on and your Edge is reset.
Restarting the Firebox
You can restart the Firebox® X Edge from a computer on the trusted
network. You can also restart the Firebox from a computer on the
Internet connected to the Firebox external interface.
The Firebox restart cycle can be 40 seconds or less. During the
restart cycle, the mode indicator on the front of the Firebox turns
off and then turns on again.
Local restart
You can locally restart the Firebox X Edge with two methods: use
the web browser or disconnect the power supply.
Using the web browser
1 To connect to the System Status page, type
https://
in the
browser address bar, and then the IP address of the Edge trusted
network interface.
The default URL is: https://192.168.111.1