Wallenstein BXMT Series, Руководство оператора

Страница: 9 / 48

2.8 Being Prepared
• Never use the machine until the operators have been
adequately trained in the safe operation of the machine and
have read and completely understand:
- safety, operation and feature sections of this manual
- the safety signs on the machine.
- engine operator's manual
- how to place the machine in a safe condition
• PPE is recommended during assembly, installation,
operation, adjustment, maintenance, repair, removal,
cleaning, and transport. Do not allow long hair, loose fitting
clothing or jewelry around equipment.
• Prolonged exposure to loud noise may
cause permanent hearing loss! Power
equipment with or without equipment
attached can often be noisy enough to
cause permanent, partial hearing loss.
• Always wear hearing protection if the noise in any area you
work in exceeds 80 dB.
- Noise over 85 dB on a long-term basis can cause
severe hearing loss.
- Exposure to noise over 90 dB over a long-term basis
may cause permanent, total hearing loss.
- Hearing loss from loud noise (from engines, chainsaws,
radios, and other such sources close to the ear) is
cumulative over a lifetime, without hope of natural
recovery.
• Clear working area of stones, branches or hidden obstacles
that might be hooked or snagged, causing injury or
damage.
• Determine where chips will be piled and ensure it does not
interfere with safe operation of the machine
• Be aware of overhead hazards: branches, cables, electrical
wires.
• Use this machine only in daylight or good artificial light.
• Perform the Pre-operation Checklist procedure before
starting work (see Pre-Operation Checklist on page 24) .
2.9 Refueling Safety
• Handle fuel with care. It is highly flammable.
• Allow engine to cool for 5 minutes before refueling. Clean
up spilled fuel before restarting engine.
• Do not refuel the machine while
smoking or fuel up near open flame or
sparks.
• Fill fuel tank outdoors.
• Prevent fires by keeping machine clean of accumulated
trash, grease and debris.
• Be sure to stop the engine prior to refueling.
• Do not overfill the fuel tank.
• If fuel is spilled, wipe it away carefully and wait until the fuel
has dried before starting the engine.
• After refueling, make sure that the fuel cap is secured to
prevent spillage.
2.10 Tire Safety
• Failure to follow proper procedures when mounting a tire on
a wheel or rim can produce an explosion which may result
in serious injury or death.
• Do not attempt to mount a tire unless you have the proper
equipment and experience to do the job.
• Have a qualified tire dealer or repair service perform
required tire maintenance.
• When replacing worn tires, make sure they meet the
original tire specifications. Never undersize.
BXMT3209
Trailer Chipper-Shredder
Safety
9
Safety