Wallenstein BXMT Series, Руководство оператора

Страница: 28 / 48

6.8 Shredder Operation
CAUTION!
Keep shredder gate closed between feeds to
keep fl ying material contained in the shredder
housing. Do not prop open the gate. Material can
fl y out causing injury.
W071
WARNING!
Never reach into the feed hopper. Doing so risks
hands getting caught. Use a stick or branch to
push in any material that does not move on its
own.
If jammed, stop the engine, wait for the rotor to
stop, then clear the jam.
W004
01086
Fig. 28 – Shredder Feed Control Handle
• Place leafy/small diameter wood material into the hopper
and then manually open the gate. Release the gate when
the material enters the shredder. When placing large,
bushy, bulky material into the hopper, most of the time the
shredder rotor will pull it in.
• Make sure the gate is closed between feeds to keep flying
material contained in the shredder housing. Do not prop
open the gate.
• If the shredder begins to slow down, stop and let the
shredder get back up to speed, then restart feeding.
• Do not reach into the shredder feed hopper further than the
gate to avoid contact with the knives on the rotor.
• Use a stick or branch to push any piece of material into
the knives that does not move on its own and stops in the
chipper housing.
6.9 Machine Break-In
Although there are no operational restrictions on the wood
chipper when used for the first time, it is recommended that the
following mechanical items be checked:
After 1–5 hours of operation:
1. Review the engine operator's manual for break-in
information.
2. Inspect the axle, tires, and wheel hubs.
3. Check tire pressure. Inflate as indicated on the tire sidewall.
4. Check belt alignment. Re-align if required. See page 35.
5. Check belt tension. Adjust if required. See page 35.
6. Check condition of rotor bearings. Make sure they are not
overheated and turn freely.
7. Check the condition and clearance of the twig-breaker, rotor
and ledger knives. Adjust as required.
8. Check for entangled material. Remove before resuming
work.
9. Check that all fasteners and hardware are tight.
After 8 hours of operation:
10. Repeat all previous steps.
11. Perform all the checks in the Pre-operation Checklist .
Operating Instructions
BXMT3209
Trailer Chipper-Shredder
28