Wallenstein BXMT Series, Руководство оператора

Страница: 34 / 48

7.5 Engine Air Cleaner
Check air filter every 50 hours of operation. Change air filter
elements every 100 hours of operation or annually.
NOTE: Refer to the engine manual for information on
servicing the air cleaner.
A dirty air filter can restrict air flow to the carburetor, reducing
engine performance. If the engine is operated in very dusty
areas, clean the air filter more often than specified
.
IMPORTANT! Operating the engine without an air
filter, or with a damaged air filter, can allow dirt to
enter the engine, causing rapid engine wear. This
type of damage is not covered by warranty.
00658
Fig. 31 –
Air Cleaner on Engine
Inspection
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged
filter elements.
1
2
3
4
00657
Fig. 32 – Air Cleaner Assembly
1. Air Cleaner Cover
2. Paper Filter Element 3. Foam Filter Element
4. Gasket
7.6 Drive Belt Replacement
The chipper has a centrifugal clutch mounted on the engine
shaft used to drive the rotor plate sheave. When the drive belt
is in disrepair or loose, the ability to efficiently drive the rotor
may be affected. Therefore, it is important to periodically check
belt condition and tension. A frayed, cracked or worn drive belt
should be replaced.
IMPORTANT! If changing or removing drive belt, always set
correct belt tension. Make sure engine and rotor sheaves
align properly.
Check drive belt tension every 100 hours of operation.
Make sure the engine is off and components are cool to touch
beforehand.
1. On the side of the chipper, remove the belt guard.
2. Loosen (do not remove) the four engine mount bolts—two
per side.
3. Turn the belt tensioning bolt counterclockwise to loosen the
belt. Loosen enough so that the engine can be slid back,
and the belt can be removed.
Service and Maintenance
BXMT3209
Trailer Chipper-Shredder
34