Wallenstein BXMT Series, Руководство оператора

Страница: 25 / 48

6.4 Engine Oil Level Check
Check engine oil level before each use.
Check with the machine parked on level ground and the engine
stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
IMPORTANT! Refer to the engine owner's manual included
in the manual tube for further information on engine oils.
1. Remove the oil level dipstick and wipe it clean.
2. Fully insert the oil level dipstick, then remove it to check the
oil level.
The proper level is when the oil is visible at the
full (upper) mark on the dipstick.
3. If the oil level is low, add oil until the level is at the full mark.
SAE 10W-30 is recommended for general use.
4. Reinstall the oil level dipstick.
2
1
01114
Fig. 18 – Engine Oil Level check
1. Oil Level Dipstick
2. Oil Filler
6.5 Starting the Engine
WARNING!
Engine exhaust contains carbon monoxide, an
odorless, poisonous gas. Breathing it can cause
unconsciousness or death.
Never operate this engine in a closed, or even
partly closed area. Exhaust gases can build up to
dangerous levels.
W072
CAUTION!
Before starting engine, review the operating and
maintenance instructions in the engine manual.
W019
Make sure the chipper is set up to work and otherwise ready to
run.
1. Slide the fuel valve lever toward the block to turn fuel ON.
01075
Fig. 19 –
Fuel valve Lever
2. If the engine is cold, close the choke (push choke lever
to the left). To start a warm engine, leave the choke open
(lever pushed to the right).
BXMT3209
Trailer Chipper-Shredder
Operating Instructions
25