Wallace Perimeter Security SPEEDGATE, Руководство по установке и обслуживанию

Страница: 134 / 142

134
wallaceperimetersecurity.com
Phone: 866.300.1110
SPEEDGATE SEMI-ANNUAL MAINTENANCE CHECKLIST
4-SPEEDGATE SEMI-ANNUAL (EVERY SIX MONTHS)
MAINTENANCE CHECKLIST
Checked Good Needs
Attention
N/A
2. Lubricate all revolving parts (every 10,000 cycles or
six months). Recommended gate hinge lubricant:
Castrol Pyroplex® Protection ES , a synthetic
lithium complex grease. Grease the gate hinge
opening leading to the pin on the top and on the
bottom, using a grease gun. Locate the Zerk fitting
(grease gun end nipple), and squirt grease into the
opening(s) until it flows from the bearing. Wipe
away any excess grease with a paper towel or shop
rag.
While it is highly important to inspect the
gate hinges for adequate lubrication every six
months/10,000 cycles, it is of equal importance to
AVOID EXCESSIVE LUBRICATION . Too much grease
being forced into a gate hinge can cause blockage
and damage to the internal rolling elements. If
existing lubrication levels appear adequate, and
there is no apparent binding or noise in proximity
to the hinges, further lubrication is unnecessary.
3. Inspect fastenings that use bolts and nuts,
specifically those of revolving elements.
4. Clean the photo eye faces with a soft, clean, dry
cloth.
5. Check the operation of the photo eyes and the gate
edges.
6. Check the movement of the gate:
6.1 Make sure that the fully closed position is
correct. Adjust drawbars and/or electronic
limits as needed.
6.2 Make sure that the fully open position is
correct. Adjust drawbars and/or electronic
limits as needed.
6.3 Ensure gate is moving smoothly.
Comments/Recommendations: