Wallace Perimeter Security SPEEDGATE, Руководство по установке и обслуживанию

Страница: 15 / 142

SPEEDGATE Installation and Maintenance Manual Revision 1 - MAY 2023
15
INSTALLATION AND COMMISSIONING CHECKLIST: SETTING GATE LIMITS
Installation and Commissioning Checklist: Setting Gate Limits
Complete Step Description
5.3.3-K Push the DOWN arrow until the gate
panels are in the fully closed position. Be
certain to check that both gate panels are
closed so that the gate panels are aligned.
PANELS CLOSED: TOP VIEW
5.3.3-L Hold the STOP button to enter this position
as the “Close Limit.”
5.3.3-M Hold the UP arrow to begin moving the
gate into the OPEN position. The display
should show a counter rapidly increasing
while the gate is moving to the fully open
position.
5.3.3-N The gate bumpers should be touching
each other. If they are, then press and
hold the STOP button to enter this value
as the “Open Limit.”
It is the installer’s responsibility to set
obstacle detection on-site. Refer to
“Gate Settings: Obstacle Detection”
on page 114.
See also “Operator Fault Codes” on
page 115. PANELS OPEN: TOP VIEW
To fine-tune the CLOSE LIMIT , close the gate
more, go to P�221 , and decrease the value
accordingly.
100 units/increments = 1 ft (0.3048m)
Password (P.999 = 4, unless changed) must
be entered to access this parameter.
To fine-tune the OPEN LIMIT , open the gate
more, go to P�230 , and increase the value
accordingly.
100 units/increments = 1 ft (0.3048m)